1. Product Identification
1.1. TECHNICAL NAME
Photopolymerizable resin cement for veneers
1.2. PRODUCT TRADE NAME
YCEM VENEER
1.3. DESCRIPTION OF THE PHYSICAL PRINCIPLE AND FUNDAMENTALS OF PRODUCT TECHNOLOGY, APPLIED TO ITS OPERATION AND ACTION
YCEM VENEER is a permanent, photopolymerizable adhesive cementing agent that promotes the joining of ceramic or composite restorations of little thickness (up to 2mm) to the dental structure. YCEM VENEER is composed of single paste, radiopaque and with several colors. YCEM VENEER is highly aesthetic, not having in its composition tertiary amines that are responsible for the yellowing of the material over time.
1.4. SPECIFICATIONS AND TECHNICAL CHARACTERISTICS
| COMPONENTS |
|---|
| Methacrylate monomers |
| Primers |
| Stabilizers |
| Pigments |
| Inorganic load |
2. Storage
YCEM VENEER must be packed between 2 and 28ºC. The YCEM VENEER product should be used at room temperature. The YCEM VENEER product should not be exposed to heat and sunlight, or other direct light sources.
3. Instructions for use
3.1. APPLICATION TECHNIQUES
3.1.1. Cementation of crowns, bridges, adhesive prostheses, inlays and onlays – Apply the silane on the inside of the part with a brush, ensuring the formation of a thin layer and with total surface coating; – Wait a minute and dry with the air jet for approximately 5 seconds; – Clean the preparations properly, removing residues from the temporary cementing material; – Keep the area isolated; – Apply the adhesive system according to the manufacturer’s instructions. Do not photopolymerize; – Select the color of the YCEM VENEER cement that will be used; – Apply a thin layer of the YCEM VENEER cement on the inner surface of the prosthetic piece or on the preparation. Use disposable micro applicator or spatula to assist in the application, thus avoiding the incorporation of bubbles; – Carefully seat the prosthetic piece, to allow the flow of the cement. Hold the piece in position and remove excess cement, especially in nearby regions and gum margins, using suitable instruments. Keep the part under pressure and photopolymerize a small area so that no displacement occurs; – Remove additional excesses and photopolymerize each region for 40 seconds; – Perform the finishing and final polishing.
4. Precautions, restrictions, warnings
4.1 PRECAUTIONS
– YCEM VENEER should be used by professionals; – Keep the product out of the reach of children
4.2. RESTRICTIONS AND WARNINGS
– Eyes: may cause moderate irritation; – Skin: may cause moderate irritation; – Ingestion: may cause gastric irritation; – Inhalation: may cause irritation of the upper respiratory tract; – Allergy: the product is contraindicated for people allergic to the components of the formula; – Avoid direct contact of YCEM VENEER with the skin and eyes. In case of contact, remove the material immediately and wash thoroughly with soap and water.
5. Indication
– YCEM VENEER is a permanent adhesive cementing agent suitable for cementing low thickness (up to 2mm) ceramic or composite restorations such as facets, contact lenses, inlays and onlays
6. Validity
See packaging for expiration dates.
Yller Biomaterials SA is not responsible for damages, of any nature, caused by incorrect use or use not foreseen in the instructions of use.
MANUFACTURED AND DISTRIBUTED BY:
Yller Biomateriais SA Address: 3852 São Francisco de Paula Ave., Areal Neighbourhood, Pelotas/RS, 96080-730 | Tel.: (53) 3027 3933 | www.yller.com.br/ | sac@yller.com.br CNPJ:16.970.346/0001-52 Technical responsible: Aline de OliveiraOgliari CRO/RS No. 19623 ANVISA [National Health Surveillance Agency] Registration No.: 81009350003 REV:02
